Natural To Lp Gas Conversion - Mendota ML39-PF2 Installation And Operating Instruction Manual

NATURAL TO LP GAS CONVERSION

Kit #HA-96-00023 for Mendota Model ML39
This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer's
instructions and all applicable codes and requirements of the authority having jurisdiction. If the infor-
mation in these instructions is not followed exactly, a fire, explosion or production of carbon monoxide may
result causing property damage, personal injury or loss of life. The qualified service agency is responsible
for the proper installation of this kit. The installation is not proper and complete until the operation of the
converted appliance is checked as specified in the owner instructions supplied with the kit.
Cet équipement de conversion sera installé par une agence qualifiée de service conformément aux instruc-
tions du fabricant et toutes exigences et codes applicables de l'autorisés avoir la juridiction. Si l'information
dans cette Instruction n'est pas suivie exactement, un feu, explosion ou production de protoxyde de carbone
peut résulter le dommages causer de propriété, perte ou blessure personnelle de vie. L'agence qualifiée de
service est esponsable de l'installation propre de cet équipement. L'installation n'est pas propre et
complète jusqu'à l'opération de l'appareil converti est chèque suivant les critères établis dans les instruc-
tions de propriétaire provisionnées avec l'équipement.
CAUTION: The electrical supply to the fireplace must be turned off prior to performing the conversion. The gas supply
must be shut off prior to disconnecting the electrical power.
ORIFICE SIZES REQUIREMENT:
A Natural Gas to LPG conversion kit #HA-96-00023 must be installed to convert the ML39 Fireplace to burn LPG.
LP Conversion Kit #HA-96-00023 contains the following parts: One Motorized LP Pressure Regulator and one Cap Ori-
fices drill #50.
Recommended Procedure to Convert This Fireplace To Burn LPG
This fireplace arrives from the factory ready to burn Natural Gas. If you intend to burn LPG, it is highly recommended that
you convert this fireplace and its Pressure Regulator, Pilot Orifice Slider Tab and Burner Orifice prior to placing this fire-
place in its framed cavity.
See diagrams, on this page, and follow instructions to prepare this fireplace for conversion to LPG.
Remove the Burner by removing 2 screws in front of burner that secure burner weldment to firebox floor.
Remove front bottom cover plates below glass frame.
Identify the Pilot Light Hood, Main Burner Orifice and the Valve Pressure Regulator.
85-03-00955 P a g e | 66