Electrical Connection - Miele TX2070 Operating Instructions Manual

Electrical connection

,
Before connecting the
appliance, ensure that it has not
been damaged in any way. Do not
use a damaged appliance.
The appliance is supplied with a mains
cable and moulded plug ready for
connection to an AC single phase 220-
240 V 50 Hz supply.
Fuse protection is to be conducted as
follows: Connection to an earthed
power socket, protected with 10 A-L
automat or fuse 10 A.
Connection must only be made via a
suitable switched socket. The electrical
system must comply with VDE 0100.
The appliance should be positioned so
that the plug is accessible.
If the switch is not accessible after
installation or the appliance is hard-
wired (depending on country), an
additional means of disconnection must
be provided for all poles.
When switched off there must be an all-
pole contact gap of 3 mm in the isolator
switch (including switch, fuses and
relays according to EN 60335).
74
The voltage, rated load and fuse rating
are given on the data plate situated at
the front of the oven interior. Please
ensure these match the household
mains supply.
If the connection cable is damaged, it
must be replaced by a Miele approved
service technician to avoid a hazard.
This appliance meets the requirements
of the European Standard EN 55011.
This appliance is classified as Group 2,
Class B. Group 2 indicates that the
appliance can be used for the purpose
of cooking food with high frequency
energy in the form of electro-magnetic
radiation. Class B indicates that the
appliance is suitable for domestic use.
Do not connect the machine to an
inverter such as those used with an
autonomous energy source e.g. Solar
power. When switched on, peak loads
in the system can cause the safety
switch-off mechanism to be triggered.
This can damage the electronic unit.
The machine must not be used with so-
called Energy saving devices either.
These reduce the amount of energy
supplied to the machine, causing it to
overheat.