Electrical Connection - Miele M 7244 TC Installation Manual

Installation

Electrical connection


Danger of injury due to a
defective appliance.
Before connecting the appliance,
ensure that it has not been damaged
in any way.
Do not use a damaged appliance.
The appliance is supplied with a power
cord and plug for connection.
Make sure that the earthed socket is
freely accessible at all times. If the
switch is not accessible after
installation an additional means of
disconnection must be provided for all
poles.

Risk of fire from overheating.
Connecting the appliance to a multi-
socket plug adapter or to an
extension lead can overload the
cable.
Do not use an extension lead or
multi-socket plug adapter.
Connect the appliance directly with
the original cable without any
intermediate elements.
The electrical system must comply with
the applicable standards and with local
and national regulations.
If the connection cable is damaged, it
must only be replaced with a specific
connection cable of the same type
(available from Miele) in order to avoid a
hazard. For safety reasons, such
replacement may only be carried out by
a qualified and competent technician or
Miele.
11195170-01
The connection data can be found on
the data plate located on the front of
the oven interior or on the back of the
appliance.
Compare the specifications on the data
plate with those of the mains electricity
supply. The data must match.
If in any doubt, consult a qualified
electrician.
The appliance must not be connected
to the inverter of an autonomous power
supply such as e.g. a solar power
system. When the appliance is switched
on, power surges could result in a
safety switch-off. This could damage
the electronics.
The appliance must not be used with
so-called energy saving devices either.
These reduce the amount of energy
supplied to the appliance, causing it to
overheat.