Problem Solving Guide - Miele TX2070 Operating Instructions Manual

,
Repairs may only be carried out
by a suitably qualified and
competent person authorised by
Miele in accordance with national
and local safety regulations. Repairs
and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held liable
for unauthorised work.
Some minor problems can be corrected
without contacting Miele. Please note,
however, that a call-out charge will be
applied to unnecessary service visits
where the problem could have been
rectified as described in these
operating instructions.
What to do if . . .
. . . a programme will not start.
Check whether,
^ the appliance door is closed
properly.
^ the system lock has been activated
(see "System lock").
^ "door" appears in the display. The
door hasn't been opened for more
than 20 minutes (see "door
message").
^ the appliance is plugged into the
mains supply and switched on at the
socket.
^ the mains fuse has tripped because
the mains voltage or another
appliance is faulty (unplug the
appliance, call a qualified electrician
or call Miele - see "After sales ser-
vice").

Problem solving guide

. . . a noise can be heard after a
cooking programme.
This is not a fault.
The cooling fan will continue to run for a
while after the microwave oven has
been switched off to prevent any
humidity building up in the oven, on the
control panel or on the oven housing
unit.
It will switch off automatically.
. . . the display does not light up.
Check whether,
^ the time of day has been switched
off.
. . . the turntable does not turn
smoothly.
^ Check whether the area underneath
the turntable is clean.
^ Check whether the surfaces between
the turntable and the roller ring are
clean.
Remove any soiling.
. . . food is not adequately defrosted,
heated or cooked at the end of the
selected cooking duration.
^ Check whether the correct power
level was selected for the duration
set.
The lower the power level, the longer
the duration required.
^ Check whether the programme has
been interrupted and not restarted.
71