Table of Contents
Advertisement
Rear Panel
q; Input option slots
9 HDMI input connector
8 DVI-D input connector
a AC IN connector (3-pin)
Connects the monitor to an AC power source, via the
supplied AC power cord.
b MAIN POWER switch
When turned on (?), the monitor enters operation mode. By
setting in Power menu of the System Configuration menu,
the monitor can also be set to enter standby mode when the
MAIN POWER switch is turned on.
For information about the Power menu, see "Power"
(page 77) of the System Configuration Menu.
c DC IN 24 - 28V (DC power input) connector (XLR
3-pin, male)
Connect the 24 to 28 V DC power supply.
Pin number
Function
1
– (GND)
2
+ (24 to 28 V DC)
3
NC
d DC 5V OUT connector (female)
Supplies the DC power to the controller.
18
Location and Function of Parts
1
2
3
1 AC IN connector
2 MAIN POWER switch
3 DC IN 24 - 28V connector
4 DC 5V OUT connector
5 LAN (10/100) connector
6 NETWORK switch
7 PARALLEL REMOTE connector
Connect to the DC 5V/12V IN connector of the controller
with the SMF-700 or the cable supplied with the BKM-
39H.
CAUTION
DC 5V OUT connector (female) is non LPS (Limited
Power Source) circuit.
ATTENTION
Le connecteur DC 5V OUT (femelle) est un circuit non
LPS (Limited Power Source, source d'alimentation
limitée).
e LAN (10/100) connector (10BASE-T/100BASE-TX)
Connect to the LAN (10/100) connector of the controller
by using the SMF-700 or the cable supplied with the BKM-
39H. Or connect to the network or the LAN (10/100)
connector of the controller by using a 10BASE-T/
100BASE-TX LAN cable (shielded-type, optional).
CAUTION
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
• When you connect the LAN cable of the unit to
peripheral device, use a shielded-type cable to prevent
malfunction due to radiation noise.
• To connect the monitor to the LAN (10/100) connector
of the controller in 1 to 1 connection (NETWORK switch
is set to PEER TO PEER), use a straight (shielded-type)
cable.
• The connection speed may be affected by the network
system.
Advertisement
Table of Contents
