Table of Contents
Advertisement
Menu
Power
Standby Mode
Power On Status
Default CH
On Screen Set
Input Information
Format
Position
CH No
Position
CH Name
Position
Scan Mode
Position
Function and operation ([
Parallel Remote (4/4)
Black Detail Mode: The display function in black detail mode
Audio Level Meter: The display function of the audio level meter
ALM Hold Reset: The function to cancel the peak hold of the audio level meter
Time Code: The display function of the time code
Checkerboard: The display function for the left and right 3D video signals in a
checkerboard pattern
L/R Switch: The display function for the left and right 3D video signals by switching
alternately
For the pin assignment, see "PARALLEL REMOTE connector" in Location and Function of
Parts on page 19.
Sets the status of the monitor when the main power is turned on or the power is turned on by
remote operation.
Sets the status when the MAIN POWER switch is turned on.
[Off]: Operation mode
On: Standby mode
Sets the input channel when the power is turned on.
[Last]: Sets to the channel that was selected at the time the power was last turned off.
CH: Sets to the channel number specified in Default CH.
Selects the channel (01 to 30) when the Power On Status is set to CH. [01]
Sets the items for the screen display.
Sets the display of the input information.
Sets the display mode of the signal system.
[Auto]: Disappears after being displayed for a while.
On: Always displayed.
Off: Not displayed.
Note
The picture rate display is 23.98, 29.97 or 59.94 (example 1080/59.94P) when the signal is
input from the BKM-250TG, Format is set to 3G/HD/SD-SDI Auto (page 52) in the Input
Configuration menu, and the Picture Rate information for the Payload ID is 23.98 Hz,
29.97 Hz or 59.94 Hz, even if the monitor determines the picture rate as 24 Hz, 30 Hz or
60 Hz.
For details on Payload ID, see "SDI Payload ID Status" (page 84) of the Status menu.
Sets the display position for the signal system.
You can select from Top Left (top left), Top Center (top center), Top Right (top right),
[Bottom Left] (bottom left), Bottom Center (bottom center) or Bottom Right (bottom right).
Sets the display mode of the channel number.
[Auto]: Disappears after being displayed for a while.
On: Always displayed.
Off: Not displayed.
Sets the display position for the channel number.
You can select from Top Left (top left), Top Center (top center), [Top Right] (top right),
Bottom Left (bottom left), Bottom Center (bottom center) or Bottom Right (bottom right).
Sets the display mode of the channel name.
[Auto]: Disappears after being displayed for a while.
On: Always displayed.
Off: Not displayed.
Sets the display position for the channel name.
You can select from [Top Left] (top left), Top Center (top center), Top Right (top right),
Bottom Left (bottom left), Bottom Center (bottom center) or Bottom Right (bottom right).
Sets the display mode of the scan mode.
[Auto]: Disappears after being displayed for a while.
On: Always displayed.
Off: Not displayed.
Sets the display position for the scan mode.
You can select from Top Left (top left), Top Center (top center), Top Right (top right),
Bottom Left (bottom left), Bottom Center (bottom center) or [Bottom Right] (bottom right).
]: factory setting)
77
System Configuration Menu
Advertisement
Table of Contents
