Table of Contents
Advertisement
Menu
Auto Adjust
Target Color Temp
x
y
Target Luminance
48
Adjustment Menu
Function and operation ([
Starts adjustment.
When Auto Adjust is selected, not only the target color temperature but also other color
temperature data are adjusted, as the color temperature of the backlight is calibrated in
accordance with the color temperature of Target Color Temp.
When Contrast Hold is set to Off, the contrast data are also adjusted, as the backlight is
calibrated in accordance of the luminance of Target Luminance.
Note
This menu is not selectable in the following case:
• When 4:4:4 XYZ 12bit or DVI Computer, or the computer signal of HDMI is selected in the
Format menu of the Input Configuration menu
Before automatic adjustment, select the value to use for the adjustment in following
sequence.
When you use the previously adjusted values for adjustment, select Auto Adjust to start
adjustment without performing step 1, step 2 and step 3.
1 Select the color temperature to be used in Target Color Temp.
When Any is selected, enter the values of the CIE color system x and y coordinates.
2 When Contrast Hold is set to Off, select Target Luminance and enter the value of the
2
luminance (cd/m
) when the 100% white signal is input.
3 Select the probe to be used in Probe.
4 Select Auto Adjust.
The following message appears.
Set probe on cursor.
Attach the probe on the center of the display to start automatic adjustment. (It may take
some time until the automatic adjustment is completed.)
Note
First select the probe and then select Auto Adjust.
To cancel/stop the adjustment
Press the MENU button.
Sets the adjustment value to be used from D93, D65, D61, D56, D-Cine or Any.
Enters the CIE color system x coordinate.
Set to 0.280 to 0.345.
Enters the CIE color system y coordinate.
Set to 0.280 to 0.352.
2
Enters the luminance (cd/m
) when the 100% white signal is input.
Adjust the luminance by the contrast adjustment (backlight adjustment).
Set to 40 to 250. [100]
Notes
• This menu is not selectable when Contrast Hold is set to On.
• The luminance is reduced to about half due to the principle of operation in the black frame
insertion mode or the interlace display mode. However, on this monitor the normal
luminance is set by the contrast adjustment (backlight adjustment). For this reason, as the
upper limit of Target Luminance becomes about 120 [cd/m
• The luminance calibrated internally by the backlight does not guarantee an absolute value
and may be different from the luminance calibrated by the probe. When you set Target
Luminance near to the upper limit (250) or the lower limit (40), the setting value may
exceed the adjustment range and cause an error. If an adjustment error occurs, change
Target Luminance and perform the automatic adjustment again.
]: factory setting)
2
], set it to less than 120 [cd/m
2
].
Advertisement
Table of Contents
