Table of Contents
Advertisement
Menu
Name
Location
Trap
Mode
Trap Address Setting
Trap Address Status
Reset Mode/Address
Authentication
Community
Protocol Setting
SDCP/SDAP Community
SDCP Port No
SDAP Port No
SDAP Broadcast
SDAP Broadcast Period
Acceptable IP Address
Reset Protocol Setting
Parallel Remote
Parallel Remote
Function and operation ([
Sets the information for the administration (device ID).
When the item is selected, you can enter a new name.
New Name: Enter a new name (up to 20 characters).
Sets the location information.
When the item is selected, you can enter a new name.
New Name: Enter a new name (up to 20 characters).
Sets the address to send the information.
Sets the settings to send information manually or automatically ([Manual] or Auto).
Sets the IP address to send the information. [000.000.000.000]
When Mode is set to Manual, you can select this item.
When the item is selected, you can set the IP address of Trap1 to Trap4.
Cancel: Cancels the changed or confirmed setting.
Confirm: Saves the changed or confirmed setting.
Displays the IP address to send the information.
When Mode is set to Auto, you can select this item.
When the item is selected, the IP address of Trap1 to Trap4 is displayed.
Resets the settings to send information manually or automatically and the IP address to the
factory setting.
When the item is selected, the following message appears.
Are you sure?
OK: To reset the data, press the ENTER (Ent) button.
Cancel: To cancel, press the MENU button.
Sets whether or not to issue the authentication ([Disable] or Enable).
Sets the community name.
When the item is selected, you can enter the community name (up to 20 characters).
public: Initially, public is entered automatically. Enter any character after it.
New Name: Enter a community name.
Sets the required items for communications such as the port number.
For the setting value, consult the network administrator.
Sets the SDCP/SDAP community name.
When the item is selected, you can enter the community name (four characters).
SONY: SONY is entered as a community name.
New Name: Enter a new name.
Sets the SDCP port number.
Set to 53434 to 53534. [53484]
Sets the SDAP port number.
Set to 53812 to 53912. [53862]
Sets whether or not to issue the SDAP (Disable or [Enable]).
Sets the period (seconds) to issue the SDAP.
Set to 05 to 30. [15]
Sets the IP address to connect.
When the item is selected, you can set IP1 to IP4.
Cancel: Cancels the changed or confirmed setting.
Confirm: Saves the changed or confirmed setting.
Resets the protocol setting.
When the item is selected, the following message appears.
Are you sure?
OK: To reset data, press the ENTER (Ent) button.
Cancel: To cancel, press the MENU button.
Sets the parallel remote function.
Selects whether or not to use the parallel remote functions. ([Off] or On)
]: factory setting)
75
System Configuration Menu
Advertisement
Table of Contents
