Displaying The Time Code; Switching The Display Of The 3D Video Signal - Sony BVM-L170 Operation Manual

Displaying the Time Code

The time code superimposed on the SDI signals is
displayed by installing the optional input adaptor (BKM-
250TG).
Note
As the time code is superimposed on the video signal, the
time code may be invisible partially because of the scan
mode setting of the monitor.
1
Input the SDI signal.
2
Select the channel.
3
Set the time code in the Time Code menu (page 78) of
the On Screen Set menu of the System Configuration
menu.
To set the type of the time code
Set in the VITC/LTC menu.
VITC: Sets to VITC.
LTC: Sets to LTC.
To set the display position for the time code
Set in the Position menu.
Top Left: To display it at top left on the screen
Top Center: To display at top center on the screen
Top Right: To display at top right on the screen
Bottom Left: To display at bottom left on the screen
Bottom Center: To display at bottom center on the
screen
Bottom Right: To display at bottom right on the
screen
4
Set Time Code (page 72) to On in the Function Switch
menu of the Display Function menu or by pressing the
Time Code button* of the controller.
The time code is displayed.
To cancel the time code display
Set Time Code (page 72) to Off in the Function Switch
menu of the Display Function menu or by pressing the
Time Code button* of the controller.
* Time Code is assigned to the function button of the controller in
the Function Key menu (page 86) of the Controller menu.
Note
Use the controller with software version 1.4 or higher to
assign Time Code function to the function button of the
controller.
Switching the Display of
the 3D Video Signal
Left (L) and right (R) 3D video signals can be displayed on
the same screen in a checkerboard pattern or switched
alternately on the screen if the optional input adaptor
(BKM-250TG with serial number 7100001 or higher) is
installed. This is useful for comparing the two signals.
You can select Checkerboard display or L/R Switch
display.
For details on the installation of the input adaptor (BKM-
250TG), see "Installing an Input Adaptor" on page 21.
Checkerboard display
Left signal (L)
Checkerboard display
The left (L) and right (R) signals are displayed in a
checkerboard pattern on the same screen for comparing the
brightness or colors of the L and R signals. For this
function, two-dimensional (2D) view is used. The signals
are not displayed in stereoscopic view.
L/R Switch display
Left signal (L)
The left (L) and right (R) signals are switched alternately
on the screen for comparing the brightness or colors of the
L and R signals. For this function, two-dimensional (2D)
view is used. The signals are not displayed in stereoscopic
view.
Procedure
1
Input 3D video signals.
Displaying the Time Code / Switching the Display of the 3D Video Signal
Right signal (R)
Right signal (R)
99