Table of Contents
Advertisement
Connect the Gas Supply Line
Check the Rating Plate attached by a steel cable to the firebox, to confirm that you have the
appropriate firebox for the type of fuel to be used. The Monterei may be converted from one gas
to another using the appropriate Fuel Conversion Kit listed on page 19.
CAUTION
This appliance should only be connected by a qualified gas technician. Test to confirm
manifold pressures as specified below. The Monterei Heater and its individual shutoff
valve must be disconnected from the gas supply piping during any pressure testing of that
system at test pressures in excess of 3.5 kPa. The Monterei Heater must be isolated from
the gas supply piping system by closing its individual manual shutoff valve during any
pressure testing of the gas supply piping system at test pressure equal to or less than
3.5kPa.
There must be a gas shutoff between the stove and the supply. In order to connect Natural
Gas, use a fitting with 3/8" NPT nipple on the valve side and 1/2" natural gas supply line
with an input of 29.5Mj at a manifold pressure of 0.87kPa and minimum inlet supply for
adjustment of 1.37kPa.
In order to connect Propane, use a fitting with 3/8" NPT nipple on the valve side and 1/2"
propane gas supply line with an input of 29.5Mj at a manifold pressure of 2.49kPa and
minimum inlet supply for adjustment of 2.74kPa.
Always check for gas leaks with a mild soap and water solution. Do not use an open flame
for leak testing.
Light the pilot according to the directions on page 16, before going to the next step.
Burner Information
The appliance must only use the gas specified on the rating plate, unless converted using a
Masport Fuel Conversion Kit. Conversion instructions are provided with each kit.
THIS APPLIANCE SHOULD BE CONNECTED TO THE GAS SUPPLY ONLY BY A
QUALIFIED GAS SERVICE TECHNICIAN. FOLLOW ALL LOCAL CODES. THERE
MUST BE A GAS SHUT-OFF BETWEEN THE STOVE AND THE SUPPLY.
Masport Monterei Direct Vent Gas Fire
16
Advertisement
Table of Contents
