REMOTE CONTROL
Set the display
•
After connecting the battery or by simultaneously pressing AUTO and TIMER, the display
flashes. You are in set mode.
•
From set mode, press AUTO to switch from ° F (and 12 hour clock) to ° C (and 24 hour
clock) or vice versa.
•
The display will automatically return to manual after some time, but you may immediately
return to manual by depressing the TIMER button.
Set the current time
•
After connecting the battery or by simultaneously pressing AUTO and TIMER, the display
flashes. You are in set mode.
•
From set mode, press ( ) to set the hour and ( ) to set the minute.
•
Wait or press TIMER to return to "manual" mode.
Programming the Desired Set Temperature
•
Press AUTO until the display flashes.
•
Press ( ) or ( ) to set the desired temperature.
•
Wait or press AUTO to switch to automatic mode.
•
A sensor in the transmitter measures the room temperature. The controller compares the
room temperature with the set temperature and sends a signal to the receiver to turn the
gas valve motor, which adjusts the flame height accordingly.
Programming the Timer
•
Press TIMER until P1* flashes (period 1, heating cycle on).
•
Set the time for the beginning of the first heating period by pressing ( ) for hour and
( ) for minute.
•
Press TIMER again; P1w appears.
•
Set the time for end of the first heating period.
•
Press TIMER again to set the second heating period P2w (heat off).
•
Store both heating periods by pressing TIMER again.
•
If only one heating period is desired, program the same time for P2* and P2w.
Manual Mode (MAN in display) for Manual Flame Height Adjustment
•
Press ( ) to turn on the fire (main burner) or to increase flame height.
•
Press ( ) to decrease flame or to turn down to pilot.
•
To incrementally increase or decrease the flame height lightly tap either the ( ) or ( )
button.
•
The "send" symbol appears in the upper left corner of the display when either button is
deprmasportd.
•
The LED of the receiver flashes when know B of the valve reaches the end stops.
Automatic Mode (AUTO in display) for Temperature Control
•
Briefly press AUTO. The set temperature will appear briefly before the display reverts to
the room temperature.
Timer Mode (TIMER in display)
•
During heating periods P1* and P2*, the temperature is controlled in the same manner
as in automatic mode.
•
When the timer program turns to w (heating cycle off), the motor will turn the valve to
pilot and there is no temperature control. This minimises battery consumption.
•
You may press AUTO to verify the set-temperature and then press TIMER to return to
timer mode.
•
You may press either the ( ) or ( ) button from any mode for manual override.
Masport Monterei Direct Vent Gas Fire
19