Table of Contents
Advertisement
Assembly Procedures
Remove the Log Set
The Log Set is inside the firebox in a protective package.
The Glass Panel must be removed to install the Log Set in the firebox.
• Swing open the swiveling latches at the top left and right corners of the glass frame. (Fig. 13)
• Pull the top edge of the glass and frame assembly away from the firebox, and lift it off its
supports on the bottom of the firebox face. Place the assembly out of the way on a flat, padded
surface such as a counter protected by a towel.
• Take the log set and all other loose parts out of the firebox, and set them aside in a protected
spot, for installation after the venting is complete.
NOTE: Verify the relief door (located at the back of the firebox) is properly seated on the
gasket. The door should sit flush on the gasket.
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved for use with this heater may result in property damage or personal
injury. This heater and components are heavy. Have help available for assembly.
WARNING
Porcelain enamelled surfaces are fragile. Handle porcelain enamelled castings with care.
Before you begin assembly, read this section of the manual to familiarize yourself with the
procedures. The installation will be easiest if you follow the steps in the order presented.
Masport Monterei Direct Vent Gas Fire
11
Advertisement
Table of Contents
