Table of Contents
Advertisement
Installation Requirements
THE INSTALLATION OF YOUR MASPORT STOVE MUST CONFORM WITH
LOCAL CODES, OR IN THE ABSENCE OF LOCAL CODES, WITH AG 601, NZS
5261
THE INSTALLATION SHOULD BE DONE BY A QUALIFIED SERVICE PERSON
WHO IS FAMILIAR WITH THE BUILDING CODES AND INSTALLATION
TECHNIQUES APPROPRIATE FOR YOUR AREA TO ACCOMPLISH A SAFE
EFFECTIVE INSTALLATION.
AND
:
WARNING
DUE TO HIGH TEMPERTURES, THE HEATER SHOULD BE
LOCATED OUT OF TRAFFIC AND AWAY FROM FURNITURE AND
DRAPERIES.
THE SURFACE OF THE HEATER IS HOT WHEN IT IS IN USE. YOUNG
CHILDREN SHOULD BE WATCHED CAREFULLY WHEN THEY ARE IN THE
SAME ROOM WHEN THE HEATER IS IN USE. OBSERVE THE
RECOMMENDED CLEARANCES THAT FOLLOW.
HEARTH REQUIREMENTS
THE MONTEREI HEATER MUST BE INSTALLED ON RIGID FLOORING.
WHEN THE HEATER IS INSTALLED DIRECTLY ON ANY COMBUSTIBLE
SURFACE OTHER THAN WOOD FLOORING, A METAL OR WOOD PANEL
EXTENDING THE FULL WIDTH AND DEPTH OF THE UNIT MUST BE USED
AS A HEARTH.
Fig.2
KEEP THE STOVE A SAFE DISTANCE FROM
SURROUNDING MATERIALS
THE MONTEREI HEATER WILL HEAT NEARBY SURFACES WHEN
OPERATING. A SAFE INSTALLATION REQUIRES THAT ADAQUATE
CLEARANCE BE MAINTAINED BETWEEN THE STOVE AND NEARBY
COMBUSTIBLE MATERIALS TO ENSURE THAT SUCH MATERIALS DO NOT
OVERHEAT. THE DIAGRAMS THAT FOLLOW ILLUSTRATE THE MINIMUM
CLEARANCES FOR THE APPLIANCE IN PARALLEL, CORNER AND ALCOVE
INSTALLATIONS.
MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS
MEASURE SIDE CLEARANCES AS SHOWN IN FIGURES 5 AND 6 FROM THE
OUTER EDGE OF THE CAST IRON STOVE TOP. MEASURE THE REAR
CLEARANCES FORM THE OUTERMOST SURFACE OF THE STEEL REAR
SKIRT.
THE MONTEREI IS APPROVED FOR ALCOVE INSTALLATION SEE FIG. 3.
Masport Monterei Direct Vent Gas Fire
5
Advertisement
Table of Contents
