senseFly swinglet User Manual page 92

Advanced functionalities
all mapping and mission parameters to their last saved default values³⁶.
• Restore factory settings: Click to restore all the parameters of this tab to
their default settings.
The last panel of this tab displays the characteristics of the flight(s) resulting from
the selected image parameters:
• Number of flights: The resulting number of flights that must be performed
to cover the chosen mission area. If the mission area cannot be mapped in
a single flight, eMotion will split it into the minimum possible number of
flights. The estimated distance that can be covered in a flight is calculated
assuming a fully charged battery and an accurate wind estimate.
• Flight time: This is the estimated flight time for each of the flights.
• Total flight distance: The total distance that will be flown during all of the
flights.
• Total ground coverage: The total area that will be mapped during all of
the flights.
• Number of flight lines: The total number of flight lines in the mission
phase of the flight plan, not including flight lines to and from the Take-off
or landing locations. The second number represents the flight lines per-
pendicular to the first number.
• Flight lines spacing: The required distance between parallel flight lines,
calculated using the Lateral overlap and Ground resolution parameters.
³⁶ Default values for mapping and mission parameters are set by clicking the 'Save parameters as de-
fault' button.
92