senseFly swinglet User Manual page 112

Advanced functionalities
least 100 m downwind and a width of 20 m in either direction from down-
wind.
2. Set the drone to an altitude of around 50 m from the landing altitude by
moving the right stick up or down.
3. Fly downwind until the drone is around 100 m away from the landing loca-
tion.
4. Turn the drone upwind and towards the landing location by moving the
right stick left or right.
5. Set the speed to a low value by moving the left stick down to around 25%
of its maximum value.
6. Bring the drone closer to the ground by controlling the sink rate with the
right stick. Keep the drone descending until it is around 5-10 m from the
ground.
7. Once the drone is around 5-10 m from the landing location, cut motor power
using the left stick and allow the drone to glide down to the ground.
6.5 Charging the remote control
When switched on, the remote control provided with the swinglet CAM displays
the battery voltage. A voltage of 4.8 V or below indicates a low battery charge.
To recharge the remote control, follow these steps:
1. Switch the remote control off.
2. Connect the remote control to its charger.
3. Wait for charging to complete, which may take several hours.
You can check the level of charge of the battery by disconnecting the charging
cable from the remote control and switching the remote control on. The battery
charge level will be displayed on the screen.
112