Transmitter Lcd Display - ROBBE BLUE ARROW NANO LOOP 2.4 GHz Operating Instructions Manual

Transmitter LCD display

Transmitter voltage display
Elevator function
Roll function
Motor speed
Yaw function
Buzzer
Yaw trimming Aileron trimming
ID-Binding:
The throttle stick must be in the "fully back" position (towards
you). Switch the transmitter on. A short beep will be sounded and
the trim settings run back and forth. As soon as the ID binding is
made, another short signal beep will sound and trims remain still.
10
Operating Instructions,BLUE ARROW NANO LOOP 2.4 GHz No. S2531
Transmitter settings
Mode display
Settings display
Elevator trimming
ELEVATOR-Reverse-setting
Throttle trimming
Click on "ENT". Use the select button for transmitter setting to
"ELEV". The "ELEV" display and "NOR" will flash. Select between
"NOR" or "REV" using R or L buttons. Press "ENT" to select and
"EXT" to finish the set up.
ROLL-Reverse-setting
Click on "ENT". Use the select button for transmitter setting to
"AILE". The "AILE" and "NOR" displays flash.The "RUDD" display
and "NOR" will flash.Select between "NOR" or "REV" using R or L
buttons. Press "ENT" to select and "EXT" to finish the set up.