Rosen DP-1001 Owner's Manual page 145

Installation Guide Toyota/Scion Series
5 - Remove the Factory Radio
You will need to remove the Factory Radio and prepare the Rosen Multi-Media unit for installation. The following steps
will help guide you through this process.
Note: Be sure to inspect all brackets and clips to ensure they were not damaged during the removal process. If any
brackets or clips were damaged, replace them prior to installation of the Rosen unit.
Step 1: Remove the OEM Radio Step 2: Unplug the Electrical
Connections
Step 3: Remove the Factory
Brackets and Clips
Step 4: Reinstall the Factory
Brackets and Clips on
the Rosen Unit
Use Caution. See the OEM Service Manual for additional information on the removal process
6 - Locate the GPS Antenna, Optional Satellite Radio Antenna and iPod Interface
You will need to mount the GPS and Optional XM/Sirius Antennas on the exterior of the vehicle. And mount the iPod
Interface Connector in the vehicle. The following steps will help guide you through this process.
Note: Please route the GPS harness away from other power harnesses in the vehicle. This will help to ensure
optimum performance of the GPS system.
Note: Please locate the iPod interface module in an area which can be serviced in the future. The iPod cable is
intended to be a serviceable item, which plugs into the iPod/Sat. Radio Interface Module.
Step 1: Mount the GPS and Sat.
Radio antenna in a
location on the exterior of
t-----.zIllI~th_e
Vehicle
Step 2: Connect the Optional
XM/Sirius Tuner as shown
below. Mount the tuner
inside the vehicle
Step 4: Locate the iPod interface
connector for use by the
end-user
It is the installer's responsibility to ensure that the safety equipment in the vehicle is NOT
adversely affected by installation of this system. Ensure that the routing of the harnesses does
NOT obstruct airbags, SRS or other safety devices.
Rosen Entertainment Systems
Instal/ation Guide
Copyright 2009 aI/ rights reserved
DP-TY0844 Rev B
Page 3