Removing Parts For Installation; Removing The Lower Tray (Lower Grease Tray) - Berbel BEH 90 FL Installation Instructions Manual

Optional accessories
Optional accessories:
1
3
For hybrid mode only:

Hybrid filter BHF 125
For recirculated air mode only:

Recirculating air filter BUF 125
Wall box BMK-F/L


Removing parts for installation

Prior to installation, certain installed parts have to
be removed or dismantled to ensure that installation
of the device is as safe and hazard-free as possible.
Carry out all of the following steps in succession.
Lay the device, with the rear side facing down, on
a flat, clean and protective surface.
The following illustrations show the installed
device. They are merely intended to provide
assistance to the installation engineer. During
these steps, the device must lie on its rear wall,
and the actions must be implemented according
to the perspective.
2
Removing the lower tray (lower grease
tray)
Open the flap by pulling it downwards at the
rounded edge.
Grip the grease tray, which is folded down
vertically, at the sides using both hands.
Raise the lower grease tray approx. 2 cm (1.).
Release the lower grease tray by pulling it
forwards (2.).
1.
Preparing for installation
2.
21