Restarting - Mercedes-Benz CLA Operator's Manual

Monitor Active Monitor Active message is shown instead
of the tire pressure display. The tire pressures
are already being monitored.
Tire pressure monitor warning mes-
sages
If the tire pressure monitor detects a pressure
loss in one or more tires, a warning message
is shown in the multifunction display and the
yellow tire pressure monitor warning light
comes on.
If the Correct Tire Pressure Correct Tire Pressure
R
appears in the multifunction display, the
tire pressure in at least one tire is too low
and must be corrected at the next oppor-
tunity.
If the Check Tire Pressure Soon Check Tire Pressure Soon
R
sage appears in the multifunction display,
the tire pressure in one or more tires has
dropped significantly and the tires must be
checked.
If the Tire Pressure Warning Tire Tire Pressure Warning Tire
R
Failure Failure message appears in the multi-
function display, the tire pressure in one or
more tires has dropped suddenly and the
tires must be checked.
Observe the instructions and safety notes in
the display messages in the "Tires" section
( page 237).
Y
i
If the wheel positions on the vehicle are
rotated, the tire pressures may be dis-
played for the wrong positions for a short
time. This is rectified after a few minutes of
driving, and the tire pressures are displayed
for the correct positions.
Restarting the tire pressure monitor
When you restart the tire pressure monitor, all
existing warning messages are deleted and
the warning lamps go out. The monitor uses
the currently set tire pressures as the refer-
ence values for monitoring. In most cases, the
tire pressure monitor will automatically
detect the new reference values after you
have changed the tire pressure. However, you
can also define reference values manually as
described here. The tire pressure monitor
then monitors the new tire pressure values.
Set the tire pressure to the value recom-
X
mended for the corresponding driving sit-
uation on the Tire and Loading Information
placard on the driver's side
B-pillar (
Additional tire pressure values for different
loads can also be found on the tire pressure
table on the inside of the fuel filler flap
( page 317).
Y
message
Make sure that the tire pressure is correct
X
on all four wheels.
Make sure that the SmartKey is in position
X
2 in the ignition lock.
Press the = or ; button on the steer-
mes-
X
ing wheel to select the
Press the 9 or : button to select
X
Tire Tire Pressure
Press the a button.
X
The multifunction display shows the cur-
rent tire pressure for each tire or the
pressure will be displayed after pressure will be displayed after
driving a few minutes driving a few minutes
Press the : button.
X
The multifunction display shows the
Current Pressures Current
Values Values
If you wish to confirm the restart:
Press the a button.
X
The Tire Press. Monitor Restarted Tire Press. Monitor Restarted
message appears in the multifunction dis-
play.
After driving for a few minutes, the system
checks whether the current tire pressures
are within the specified range. The new tire
pressures are then accepted as reference
values and monitored.
If you wish to cancel the restart:
Press the % button.
X
The tire pressure values stored at the last
restart will continue to be monitored.
Tire pressure
page 317).
Y
Service Service
Pressure.
message.
Pressures as as New New Reference
message.
323
menu.
Tire Tire
Use Use
Reference
Z