Floormats - Mercedes-Benz CLA Operator's Manual

Calibrating the compass
Make sure that there is sufficient space for
X
you to drive in a circle without impeding
traffic.
In order to calibrate the compass correctly,
do the following:
calibrate the compass in the open and not
R
in the vicinity of steel structures or high-
voltage transmission lines.
switch off electrical consumers such as the
R
climate control, windshield wipers or rear
window defroster.
close all doors and the trunk lid.
R
Switch on the ignition.
X
Push a round pen into opening =
X
( page 278) for approximately six sec-
Y
onds, until symbol
display ; ( page 278).
Y
Drive your vehicle in a full circle at approx-
X
imately 3 mph (5 km/h) to 6 mph
(10 km/h).
When the calibration has successfully been
completed, the current direction is shown
in compass display ; (
Floormat on the driver's side
G WARNING
Objects in the driver's footwell can restrict the
pedal travel or obstruct a depressed pedal.
The operating and road safety of the vehicle is
jeopardized. There is a risk of an accident.
Make sure that all objects in the vehicle are
stowed correctly, and that they cannot enter
the driver's footwell. Install the floormats
securely and as specified in order to ensure
sufficient clearance for the pedals. Do not use
loose floormats and do not place floormats on
top of one another.
C C is shown in compass
page 278).
Y
Slide the seat backwards.
X
To install: place the floormat in the foot-
X
well.
Press safety catch knobs : onto retain-
X
ers ;.
To remove: pull the floormat off retain-
X
ers ;.
Remove the floormat.
X
Features
279
Z