Panorama Roof With Power Tilt/Sliding Panel - Mercedes-Benz CLA Operator's Manual

WARNING
G
At high speeds the raised sliding sunroof auto-
matically lowers slightly at the rear. This could
trap you or other persons. There is a risk of
injury. Make sure that nobody reaches into
the sweep of the sliding sunroof whilst the
vehicle is in motion.
If somebody becomes trapped, immediately
pull back the sliding sunroof switch. The slid-
ing sunroof lifts during opening.
! Only open the sliding sunroof if it is free of
snow and ice. Otherwise, malfunctions may
occur.
Do not allow anything to protrude from the
sliding sunroof. Otherwise, the seals could
be damaged.
! The weather can change abruptly. It could
start to rain or snow. Make sure that the
sliding sunroof is closed when you leave the
vehicle. The vehicle electronics can be
damaged if water enters the vehicle inte-
rior.
i Resonance noises can occur in addition to
the usual airflow noises when the sliding
sunroof is open. They are caused by minor
pressure fluctuations in the vehicle interior.
Change the position of the sliding sunroof
or open a side window slightly to reduce or
eliminate these noises.
Sliding sunroof reversing feature
The sliding sunroof is equipped with an auto-
matic reversing feature. If a solid object
blocks or restricts the sliding sunroof during
the closing process, the sliding sunroof opens
again automatically. The automatic reversing
feature is only an aid and is no substitute for
your attention when closing the sliding roof.

Panorama roof with power tilt/sliding panel

G
The reversing feature does not react:
to soft, light and thin objects, e.g. small fin-
R
gers
over the last 1/6 in(4 mm) of the closing
R
movement
during resetting
R
when closing the sliding sunroof again man-
R
ually immediately after automatic reversing
This means that the reversing feature cannot
prevent someone being trapped in these sit-
uations. There is a risk of injury.
Make sure that no body parts are in close
proximity during the closing procedure.
If somebody becomes trapped:
release the switch immediately, or
R
during automatic operation, push the
R
switch briefly in any direction
The closing process is stopped.
Operating the sliding sunroof
Overhead control panel
To raise
:
To open
;
To close/lower
=
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Make sure that the roller sunblinds are
X
open.
Press or pull the 3 switch in the corre-
X
sponding direction.
WARNING
91
Z