Floormats - Mercedes-Benz 2016 GLC Operator's Manual

ous angles at a distance between 2and
12 inches (5to 30 cm) or at the same angle
but at varying distances.
If another remote control is available for the
R
same garage door drive, repeat the same
programing steps with this remote control.
Before performing these steps, make sure
that new batteries have been installed in
garage door drive remote control A.
Note that some remote controls only trans-
R
mit for a limited amount of time (the indi-
cator lamp on the remote control goes out).
Press button B on remote control A again
before transmission ends.
Align the antenna cable of the garage door
R
opener unit. This can improve signal recep-
tion/transmission.
Opening/closing the garage door
After it has been programmed, the integrated
garage door opener assumes the function of
the garage door system's remote control.
Please also read the operating instructions
for the garage door system.
Turn the SmartKey to position 2 in the igni-
X
tion lock ( page 153).
Y
Press button ;, = or ? that has been
X
programmed to operate the garage door.
Garage door system with a fixed code: indi-
cator lamp : lights up green.
Garage door system with a rolling code:
indicator lamp : flashes green.
The transmitter will transmit a signal as
long as the button is pressed. The trans-
mission is halted after a maximum of ten
seconds and indicator lamp : lights up
yellow.
Press button ;, = or ? again if neces-
X
sary.
Clearing the memory
Make sure that you clear the memory of the
integrated garage door opener before selling
the vehicle.
Turn the SmartKey to position 2 in the igni-
X
tion lock ( page 153).
Y
Press and hold buttons ; and ?.
X
The indicator lamp initially lights up yellow
and then green.
Release buttons ; and ?.
X
The memory of the integrated garage door
opener in the rear-view mirror is cleared.

Floormats

WARNING
G
Objects in the driver's footwell can restrict the
pedal travel or obstruct a depressed pedal.
The operating and road safety of the vehicle is
jeopardized. There is a risk of an accident.
Make sure that all objects in the vehicle are
stowed correctly, and that they cannot enter
the driver's footwell. Install the floormats
securely and as specified in order to ensure
sufficient clearance for the pedals. Do not use
loose floormats and do not place floormats on
top of one another.
Slide the relevant seat back.
X
To install: place the floormat in the foot-
X
well.
Press studs : onto retainers ;.
X
To remove: pull the floormat off retain-
X
ers ;.
Remove the floormat.
X
Features
335
Z