Floormats - Mercedes-Benz SLC Operator's Manual

Features
230
Calibrating the compass
Make sure that there is sufficient space for
X
you to drive in a circle without impeding traf-
fic.
In order to calibrate the compass correctly, do
the following:
calibrate the compass in the open and not in
R
the vicinity of steel structures or high-voltage
transmission lines.
switch off electrical consumers such as the
R
climate control, windshield wipers or rear win-
dow defroster.
close all doors and the trunk lid.
R
Switch on the ignition.
X
Push a round pen into opening =
X
( page 229) for approximately six seconds,
Y
until symbol C
( page 229).
Y
Drive your vehicle in a full circle at approx-
X
imately 3 mph (5 km/h) to 6 mph (10 km/h).
When the calibration has successfully been
completed, the current direction is shown in
compass display ; (

Floormats

G
WARNING
Objects in the driver's footwell can restrict the
pedal travel or obstruct a depressed pedal.
The operating and road safety of the vehicle is
jeopardized. There is a risk of an accident.
Make sure that all objects in the vehicle are
stowed correctly, and that they cannot enter
the driver's footwell. Install the floormats
securely and as specified in order to ensure
sufficient clearance for the pedals. Do not use
loose floormats and do not place floormats on
top of one another.
is shown in compass display ;
page 229).
Y
Slide the seat backwards.
X
To install: place the floormat in the footwell.
X
Press studs : onto retainers ;.
X
To remove: pull the floormat off retainers ;.
X
Remove the floormat.
X