Mode Switch Password Programming; To Establish Or Change The Secret Code; To Log On The Secret Code - Sam4s ER-150II Programming & Operation Manual

Mode Switch Password Programming

The ER-150II has the added feature of an extra security function to limit
access to certain phases of operation. Through optional programming,
you may require a four digit code before allowing access to the Z and P
modes. When the mode switch is changed to a protected mode, the
buzzer sounds until the switch is returned to an unprotected mode. If no
mode protection is required then you may disregard this section.

To Establish or Change the Secret Code

1. Set the mode lock to the X position.
2. Press #/NS
3. Enter the four digit code
4. Press the RA key for Z mode protection.
Press the PO key for P mode protection.
Example: Set Code for Z Mode To 1111
#/NS
Example: Set Code for P Mode To 2222
#/NS
Note : The four digit code protection can be disabled by entering before
four zero's as the code number using the same sequence as above.

To Log on the Secret Code

To enter the Z or P modes once protection is established:
1. Place the mode switch in the X position
2. Press the (−) minus key.
3. Enter your four-digit code.
4. Press the % discount key.
22
1 1
2 2
1 1
2 2
RA
PO