Table of Contents
Advertisement
Operation Mode: Choose one of the two modes, NAT mode and Router mode, by the requirements.
IP Address: Enter the desired IP address for the LAN1~LAN4 port.
Subnet Mask: Enter the desired subnet mask for the LAN1~LAN4 port.
DHCP Server Configuration
There are three methods to set the DHCP server: Disable DHCP Server, Enable DHCP Server and Enable
DHCP Relay.
1. Disable DHCP Server: Disable DHCP Server function.
2. Enable DHCP Server: Choose "Enable DHCP Sever" function and set the appropriate configuration for
the DHCP server. The fields with red asterisk are required. Please fill in these fields.
DHCP Scope: Enter the "Start IP Address" and the "End IP Address" of this DHCP block. These fields
define the IP address range that will be assigned to the Public LAN clients.
Preferred DNS Server: The primary DNS server for the DHCP.
Alternate DNS Server: The substitute DNS server for the DHCP.
29
Advertisement
Table of Contents
