Table of Contents
Advertisement
Software Configuration
3.2.
3.2.1. Quick Configuration
There are two ways to configure the system: using Configuration Wizard or change the setting by demands
manually. The Configuration Wizard provides a simple and easy way to guide you through the setup of AMG-2000
(for the AP configuration, you have to set it up in administrator interface). You just need to follow the procedures and
instructions given by the Wizard to enter the required information step by step. After saving and restarting
AMG-2000, it is ready to use. There will be 6 steps as listed below:
1. Change Admin's Password
2. Choose System's Time Zone
3. Set System Information
4. Select the Connection Type for WAN Port
5. Set Authentication Methods
6. Save and Restart AMG-2000
Please follow the following steps to complete the quick configuration.
1.
Use the network cable of the 10/100BaseT to connect a PC to one of the LAN1~LAN4 port, and then start a
browser (such as Microsoft IE or Firefox). Next, enter the gateway IP address as the web management
interface's URL, the default is https://192.168.2.254. In the opened webpage, you will see the login screen.
Enter "admin", the default username and password, in the User Name and Password column. Click Enter to
log in.
Caution: If you can't get the login screen, the reasons may be: 1. The PC was set incorrectly so that the PC can't
obtain the IP address automatically from the LAN port; 2. The IP address and the default gateway are not under the
same network segment. Please use default IP address such as 192.168.2.xx in your network and then try it again.
For the PC configuration on PC, please refer to 6. Appendix B – Network Configuration on PC
AMG-2000 supports three accounts with different access privileges. You can log in as admin, manager or operator.
10
Advertisement
Table of Contents
