Table of Contents
Advertisement
3.1.4. Installation Steps
Please follow the following steps to install AMG-2000:
1. Connect the DC power adapter to the power connector socket on the rear panel. The Power LED should be on
to indicate a proper connection.
2. Connect an Ethernet cable to the WAN1 Port on the rear panel. Connect the other end of the Ethernet cable to
ADSL modem, cable modem or a switch/hub of the internal network. The LED of WAN1 Port should be on to
indicate a proper connection.
3. Connect an Ethernet cable to Private Port on the rear panel. Connect the other end of the Ethernet cable to a
client's PC. The LED of Private Port should be on to indicate a proper connection. (Note: No authentication is
required for the users to access the network via Private Port and the administrator can enter the web
management interface to perform configurations via Private Port.)
4. Connect an Ethernet cable to one of the LAN1~LAN4 Port on the rear panel. Connect the other end of the
Ethernet cable to an AP or switch. The LED of the LAN Port should be on to indicate a proper connection. (Note:
Authentication is required for the users to access the network via these LAN Ports.)
Attention: Usually a straight-through cable could be applied when the AMG-2000 connects to an Access Point
which supports automatic crossover. If after the AP hardware resets, the AMG-2000 could not be able to connect to
the AP while connecting with a straight-through cable, the user have to pull out and plug-in the straight-through
cable again. This scenario does NOT occur while using a crossover cable.
After the hardware of AMG-2000 is installed completely, the system is ready to be configured in the following
sections.
9
Advertisement
Table of Contents
