Acura 2002 RSX Service Manual page 125

Hide thumbs Also See for 2002 RSX:
Table of Contents

Advertisement

Gylinder Head
WEC Rocker Arms Test (cont'd)
10. Loosen the valve on the regulator, and apply the
specified air pressure.
Specitied air pressure:
290 kPa {3.0 kgf/cm', ,[2 psi]
NOTE: lf the synchronizing piston ooes not move
after applying air pressure; move the primary or
secondary rocker arm up and down manually by
rotating the crankshaft clockwise.
1'1. With the specified air pressure applied, move the
intake primary rocker arm (A) for the No. j cylinder.
The primary rocker arm and secondary rocker arm
(B) should move together.
. lfthe intake secondary rocker arm does
not move.
remove the primary and secondary rocker arms
as an assembly and check that the pistons in the
pnmary and secondary rocker arms move
smoothly. lf any rocker arm needs replacing,
replace the primary and secondary rocker arms
as an assembly, and test.
1 4 .
' 1 2 .
Remove the special tools.
Tighten the camshaft holder mountjng bolts to
2 2 N . m 1 2 . 2 k g f . m , 1 6 t b f . f t ) .
T i g h t e n t h e s e a l i n g b o l t t o 2 0 N . m ( 2 . 0 k g f . m ,
14 tbf.ft).
Installthe cylinder head cover (see page 6-46),
1 3 .
't5.
6-8
K20A2 engine:
1. Remove the cylinder head cover (see page 6-25).
2. Setthe No. 1 piston atTDC (see step 1 on pagea
't
41.
3. l\4ove the secondary rocker arm (A) for No. 1
cylinder. The secondary rocker arm should move
independently ofthe mid rocker arm (B).
. lf the secondary rocker arm does not move,
remove the mid, primary. and secondary rocker
arms as an assembly, and check that the pistons
in the rocker arms move smoothly. lf any rocker
arm needs replacing, replace the mid, primary,
and secondary rocker arms as an assembly, and
IESI.
. lf the secondary rocker arm movesfreely,
go to step 4.
Repeat step 3 on the remaining secondary rocker
arms with each piston at TDC. When all the
secondary rocker arms pass the test, go to step S.
Check that the air pressure on the shop air
compressor gauge indicates over 400 kpa
(4 kgf/cm', 57 psi).
Inspectthe valve clearance (see page 6-1 1).
5 .

Advertisement

Table of Contents
loading

This manual is also suitable for:

2003 rsx

Table of Contents