Log Placement 400/500 Series - Vermont Castings KHLDV400PTSCSB Installation And Operating Instructions Manual

KHLDV Series Gas Fireplace
LOG PLACEMENT— 400/500 SERIES
Burner Grate Assembly
1. Place the rear log over the grate toward the back by
positioning the holes over the large pins located at the
right and left. When the log is in place, the back surface
of the log will come in contact with the light trapezoid
defl ector.
Step 1
2. Place the log over the pilot by holding the log with the
wide end toward the back and the branch toward the
front and left. Set the log by having the protrusion on the
bottom of the log rest to the left side of the grate bar and
behind the pilot shield. Also set the notch located at the
bottom of the left branch over the second right tong on
the grate. Make sure that the log is positioned properly
so it is not rocking. NOTE: When the log is in place,
it should not touch the pilot but will be resting over
the pilot shield.
48
LG593
Step 2
3. Place the left front log in place by setting it over the left
side of the rear log (match protrusion to indentation), the
hearth brick and over the left tong on the grate. Match
the notch at the bottom of the branch with the tong on
the grate.
LG594
Step 3
4. Place the middle log over the two burners by setting the
fl at surface over the burner and matching the indenta-
tion located underneath the branch over the protrusion
located at V-branch on the left front log placed in step #3.
Rotate the right end of the log clockwise until it comes
in contact with the reverse bend on the bracket located
between the front and rear burner.
FINAL INSTALLATION
LG595
LG596
20306742