Table of Contents
Advertisement
Quick Links
INSTALLER / CONSUMER
SAFETY INFORMATION
Please read this manual before
installing and using appliance.
WARNING: If the information in this
manual is not followed exactly, a fire
or explosion may result causing
property damage, personal injury or
loss of life.
—Do not store or use gasoline or
other flammable vapors and
liquids in the vicinity of this or
any other appliance.
—WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appli-
ance.
• Do not touch any electrical
switch; do not use any phone
in your building.
• Immediately call your gas
suppler from a neighbor's
phone. Follow the gas
suppler's instructions.
• If you cannot reach your gas
supplier, call the fire depart-
ment.
Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
This is an unvented gas-fired heater.
It uses air (Oxygen) from the room
in which it is installed. Provisions for
adequate combustion and
ventilation air must be provided.
Refer to Page 7.
INSTALLER: DO NOT DISCARD THIS MANUAL - LEAVE FOR HOMEOWNER
UVS27R, UVS27M
Vent Free Gas Heaters
Models 3030, 3031,
CFM Specialty Home Products
410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7777
www.majesticproducts.com • www.vermontcastings.com
3032, 3033
Homeowner's Installation
and Operating Manual
Tested and listed to
ANSI Z21.11.2a-2001, Unvented Heaters
20005004 10/04 Rev. 4
Advertisement
Table of Contents
Related Manuals for Vermont Castings 3030
Summary of Contents for Vermont Castings 3030
- Page 1 Refer to Page 7. INSTALLER: DO NOT DISCARD THIS MANUAL - LEAVE FOR HOMEOWNER UVS27R, UVS27M Vent Free Gas Heaters Models 3030, 3031, Homeowner’s Installation and Operating Manual CFM Specialty Home Products 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7777 www.majesticproducts.com •...
-
Page 2: Table Of Contents
Vermont Castings UVS27 Vent-Free Gas Heater PLEASE READ THE INSTALLATION & OPERATING INSTRUCTIONS BEFORE USING APPLIANCE. Thank you and congratulations on your purchase of a Vermont Castings stove. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty. -
Page 3: Installation And Operating Instructions
Installation & Operating Instructions In order to ensure safe and effective installation, this unit must be installed only by a qualified agency, individual, firm, corporation or company that is experienced in the installa- tion, repair and servicing of this type of appliance and is familiar with the building codes and installation techniques appropriate in your area. -
Page 4: Shell Dimensions
Vermont Castings UVS27 Vent-Free Gas Heater Freestanding Stove (680mm) Drawing Not to Scale Fig. 1 UVS27 freestanding shell dimensions. Hearthmount 25 " (641mm) Drawing Not to Scale Fig. 2 UVS27 Hearthmount specifications. Shell Dimensions 9" (229mm) Valve Inlet 26 " Valve Inlet 3"... -
Page 5: Clearance Requirements
Clearance Requirements Minimum Clearances to Combustible Materials Maintain clearance, (empty space), between combus- tible materials and the heater as specified below for the appropriate firebox shell being installed. Freestanding Stove Hearthmount A: Mantel/Trim* ... 35” (889mm) / 2” (51mm) B: Side Wall/Trim* ... 2” (51mm) C: Rear Wall ... -
Page 6: Gas Specifications
Vermont Castings UVS27 Vent-Free Gas Heater Gas Specifications Model Fuel Gas Control UVS27RN Millivolt UVS27RP Prop Millivolt UVS27MN Millivolt UVS27MP Prop Millivolt Firebox weight / shipping 110 lbs. Gas Inlet and Manifold Pressures Natural Inlet Minimum 5.5” w.c. Inlet Maximum 14”... -
Page 7: Vent Free Features
Vent Free Features The UVS27, Model Nos. 3030 thru 3033, is an unvented gas heating appliance tested and listed to the ANSI standard Z21.11.2a-2001. This appliance is specifically configured to burn either Natural Gas or Propane fuel, as indicated on the metal rating plate attached to the rear shroud. - Page 8 Vermont Castings UVS27 Vent-Free Gas Heater Example: A room that is 18' x 12' x 8' has a volume of 1728 cubic feet, ( length x width x height). An adjoining open kitchen that is 10' x 12' x 8' has a volume of 960 cubic feet.
-
Page 9: Assembly Procedures
Refer to the specific assembly instructions for the shell appropriate to your UVS27R or UVS27M Heater installation. NOTE: If you intend to hard-plumb the gas supply line to the burner, you may wish to install the union or elbow at the burner control valve inlet before installing the firebox within the shell. -
Page 10: Install Optional Fan Kit
Vermont Castings UVS27 Vent-Free Gas Heater Fig. Secure right side to the back panel. ST105 Screw & Washer Shell assy 4/15/99 djt Back Panel Side Plate Fig. 7 The sides must be at right angles to the back panel in order for the firebox to fit properly. -
Page 11: Install On/Off Switch
Fig. 10 Place upper flange behind lower edge of shroud. Fig. 11 Correct position of fan skirt installation. Fig. 12 Attach snapstat to inner shroud. Retaining Nut Rheostat Fig. 13 Attach rheostat to bracket. 20005004 Vermont Castings UVS27 Vent-Free Gas Heater Upper Flange ST344... -
Page 12: Thermostat Connections
Vermont Castings UVS27 Vent-Free Gas Heater On/Off Switch Wiring TP/TH Black Optional Thermostat/Remote Wiring TP/TH Black Fig. 17 ON/OFF switch and optional Thermostat/Remote wiring. Thermostat Connection (Optional) Use only a thermostat rated for 500 - 750 millivolts. Do not use low voltage (24V) thermostats. Check the table below for the appropriate gauge thermostat wire to use for the length of lead required in your installation. -
Page 13: Connect The Gas Supply Line
Left Burner Leg Injector Orifices 90¡ Fig. 20 Be sure injector orifices remain at 90° to the base. shoulders are inside the burner. 5. Replace rear, left and right log bracket assembly and replace logs. 6. Shoulder bolts provided in catalyst kit must be installed on top of firebox. -
Page 14: Install Log Set
Vermont Castings UVS27 Vent-Free Gas Heater CAUTION This appliance should only be connected by a qualified gas techni- cian. Test to confirm manifold pressures as specified below. The UVS27 and its individual shutoff valve must be disconnected from the gas supply piping during any pressure testing of that system at test pressures in excess of 1/2 psig (3.5 kPa). -
Page 15: Complete The Installation
Complete the Installation 1. Install the screen frame by sliding the hooks over the top front edge of the firebox and resting the bottom on the support brackets. If the catalyst has been installed, place the glass front on the stove by resting the bottom edge of the frame on support brackets below the front opening of the firebox. -
Page 16: Operation
Vermont Castings UVS27 Vent-Free Gas Heater Your First Fire Read these instructions carefully and familiarize yourself with the burner controls shown on Page 18. Locate the pilot assembly, Figure 28. Follow the lighting instructions on Page 17 exactly. During the first fire, it is not unusual to smell some odor associated with new logs, paint and metal being heated. -
Page 17: Lighting Instructions
Lighting and Operating Instructions FOR YOUR SAFETY READ BEFORE LIGHTING WARNING:If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This heater has a pilot which must be lit manu- ally. -
Page 18: Troubleshooting
Vermont Castings UVS27 Vent-Free Gas Heater Follow these procedures in the order presented. CONDITION No spark at pilot when Ignitor is operated. The Ignitor Electrode sparks, but Pilot does not light. Piezo Ignitor Regulator HV104 Fig. 33 Honeywell valve assembly. Troubleshooting W A R N I N G TURN OFF HEATER AND ALLOW TO COOL... - Page 19 Troubleshooting cont’d. CONDITION Pilot lights but flame goes out when Control Knob is released. Pilot flame is lifting. Thermopile Thermo- couple ST121a Pilot flame is weak - does not touch Thermocouple. Correct LP Pilot Flame. Pilot lights but Main Burner does not.
-
Page 20: Maintenance
Vermont Castings UVS27 Vent-Free Gas Heater The following procedures will help ensure that your heater continues to perform safely and efficiently. Firebox Cleaning and Inspection Cleanliness is critical to correct operation of the heater. The log set, burner, valve controls and air circulation areas must all be kept free of dust and unobstructed by debris. -
Page 21: Catalytic Combustor
Catalytic Combustor The combustor should be cleaned annually to ensure optimal performance. Follow the procedure below. Remove the Combustor Module 1. Be sure the heater is COLD. 2. Remove the top grille, screen and top plate. (Fig. 35) 3. Use the phillips screwdriver to remove the two sheet metal screws and washers that secure the combus- tor to the top of the firebox. -
Page 22: Replacement Parts
CFM Specialty Home Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. UVS27R, UVS27M Vent Free Gas Heaters Models 3030, 3031, 3032, 3033 Ref. Description Gas Log Assembly - UVS27... - Page 23 UVS27R, UVS27M Vent Free Gas Heaters Models 3030, 3031, 3032, 3033 (continued) Ref. Description Manifold Assy. - UVS27R Manifold Assy. - UVS27M Damper Steel Handle/Screw (Stardance Operable Door Only) Handle Package, Ceramic w/Screw (Stardance Operable Door Only) Trim ON/OFF Switch...
- Page 24 Vermont Castings UVS27 Vent-Free Gas Heater UVS27R, UVS27M Vent Free Gas Heaters Models 3030, 3031, 3032, 3033 (continued) Shell Enamel Part Numbers - Hearthmount Color Classic 1301083 Sand 1321083 Midnight 1341083 Shell Enamel Part Numbers - Freestanding Color Left End...
-
Page 25: Optional Accessories
Optional Accessories Available Fan Kits FK28 Fan Assembly The FK28 fan kit helps distribute heated air from within the firebox out into the room. The fan is controlled by a snapstat that turns power on and off as the firebox temperature rises above and falls below a preset temperature. -
Page 26: Warranty
Vermont Castings UVS27 Vent-Free Gas Heater PRODUCT COVERED BY THIS WARRANTY All Vermont Castings gas stoves, gas inserts, and gas fireplaces, and all Majestic or Northern Flame brand gas fireplaces equipped with an Insta-Flame Ceramic Burner, or standard steel tube burner. BASIC WARRANTY CFM Specialty Home Products (hereinafter referred to collectively as the Company) warrants that your new Vermont Castings or Majestic...