Rock Wool And Log Placement; Rock Wool Placement; Log Placement - Vermont Castings ICFDV Series Installation And Operating Instructions Manual

ICFDV30 Fireplace Insert
Do not use the entire bag of rock wool
to cover burner area.

ROCK WOOL PLACEMENT

Ember Material Area
Figure 21 -
Ember Material Placement
Fp2961
ember material area
Ember Material
Figure 22 -
Ember Material Placement
LG1116
WARNING: The positioning of the
ICFDV ember material
logs is critical to the safe and clean
operation of this heater. Sooting and
other problems may result if the logs
are not properly and firmly positioned in the
appliance. Never add additional logs or embel-
lishments such as pine cones or vermiculite
to the heater. Only use the logs supplied with
the unit.
Failure to position the parts in accordance
with diagrams below or to use only parts spe-
cifically approved for this heater may result in
property damage or personal injury.
20

ROCK WOOL AND LOG PLACEMENT

Before you begin - This unit is supplied with six (6) ceramic
fiber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from
ceramic fibers. After handling the logs, wash your hands
gently with soap and water to remove any traces of fibers.

LOG PLACEMENT

1. Break up rock wool (ember material) into small fluffy
pieces. Place evenly as shown. Do not exceed 1" layer
covering all round burner ports. Refer to Figures 21 and
22.
2. Apply a light layer of embers to the ports. NOTE:
Excessive amount of embers will affect the flame and
the flame appearance.
3. Align the two pin holes on Log #1 onto the burner. Figure
23
4. Place log #2 by aligning the holes to the burner pin.
Figure 23
Log #1
Figure 23
5. Position log #3 so that it is resting on log #2. Figure
LG1117
24.
ICFDV logs 1 2
Figure 24
LG1118
Log #2
Log #3
20306752