Adjustable Baffle; Log Placement - Vermont Castings 33CFDVNV Installation And Operating Instructions Manual

CFDV Series Gas Fireplace
WARNING
The use of too much rock wool could cause flame
to burn poorly and may cause sooting.
Rock Wool
Figure 83 –
Placement of Rock Wool on Burner

ADJUSTABLE BAFFLE

NOTE: An adjustable baffle plate is shipped in the maxi-
mum open position secured to the false bottom. The baffle
plate may be adjusted forward up to 3/8" to fully close to
regain the flame height by restricting air flow to the burner
for some applications. Figure 84
Figure 84 –
Adjustable Baffle
FP3039
flat baffle
50
False Hearth
Adjustable Baffle
FP3039

LOG PLACEMENT

1. Place rear log (#1) on the two (2) brackets in the back
of the firebox. The log should be placed between the
two bent tabs on the right and left, and rest against the
two rear tabs. Figure 85
Figure 85
2. Place the bottom left and right logs (#2 & #3) on the two
(2) pins located on the left and right sides of the false
hearth toward the front. Figure 86
Bottom Left Log #2
Figure 86
3. Bend the tab in the center front of the false hearth up to
a 90° angle. Figure 87. Place the top log (#4) by resting
the square notch located on the bottom of the log over
the tab mentioned above. Rest the top part of the log
on the flat areas of the rear log. Figure 88
FINAL INSTALLATION
Rear Log #1
Bottom Right Log #3
20306739