Part Names And Functions; Top Panel - Denon DN-X1600 Owner's Manual

ENGLISH

Part Names and Functions

Top Panel

E4 E5
R3
E3
E2
E1
E0
W9
W8
W7
W6
W5
W4
W3
W2
W1
W0
4
E6 E7 R1 R2
E8
E9
R0
Q7
Q9 Q8 Q6 R4
q
MASTER LEVEL control
Adjusts the level of the MASTER outputs.
w
Master EFX INS button
This button enable the various effects to be
obtained for the master output signals.
e
BOOTH LEVEL control
Adjusts the level of the BOOTH outputs.
r
USB ASSIGN CH/MASTER indicator
This displays the assignment destination of
the USB Audio input signal supplied from the
q computer.
Assignment destination settings for Ch and
Master are selected from the USB Assign items
w
in the preset controls in the utility mode.
CH:
•
Displayed when CH (1–4) are assigned.
e
MASTER:
•
Displayed when assigned to the master bus
r
and monitor bus.
t
t
MIDI CLK / V-LINK button
y
This enables the MIDI clock corresponding to
R5
the BPM value to be sent from the USB MIDI
R6
and MIDI output terminals to the computer
(software) or external device.
START:
Sending the MIDI clock is started.
STOP:
Sending the MIDI clock is stopped.
u
•
Press for more than one second to switch
i
V-LINK ON/OFF .
y
UTILITY/–USB A/USB B button
o
This allows the presets to be set and the system
Q0
information to be set, changed or referenced.
•
Q1
When it is held down for more than a second,
Q2 the USB mode switching screen is opened,
and the USB device mode or USB host mode
Q3
can be selected.
u
BEAT , buttons
Q4
(Short) :
The beat/time is decreased.
Q5
(Long) :
The beat/time is increased.
i
TAP/LOCK/AUTO/INPUT BPM button
TAP:
When this button is tapped repeatedly, the BPM
is measured using the intervals between taps.
LOCK:
When the button is pressed once in the
auto BPM mode, the BPM value measured
automatically is locked.
AUTO BPM:
When the button is held down for one second,
the auto BPM mode is established, and the
measured BPM value is displayed.
INPUT BPM:
When it is held down for two or more seconds,
the BPM input mode is established, and the
BPM value can be input directly using the
u
BEAT , buttons. When it is pressed
again, the mode is released.
o
Effect CUE button
When the CUE button is set to ON, the sound of
the effects can be monitored even if the effect
is OFF.
(Excluding ECHO, REVERB, and
REVERB.)
Q0
TIME/BACK button
TIME:
This button is used to select whether to change
u
the effects produced using the BEAT
buttons on the basis of the number of beats
or time.
BACK:
This is used when returning to the previous
screen while setting screen operations are
being performed.
Q1
EFX SELECT control
This is for selecting the effect to be used.
Refer to the effect functions (page 12).
Q2
PARAMETER MIN/MAX control
This is used to adjust the fi lter cutoff frequency
and other effector parameters. The parameters
are changed by the effector selected.
Q3
Parameter ON/OFF button
This is used to control the ON and OFF settings
of the effect parameters.
Q4
DRY/WET control
Use this to adjust the ratio of original and
effected sound.
ECHO
,