Troubleshooting - Denon DN-X1600 Owner's Manual

Troubleshooting

n Are all the parts connected properly?
n Have the operations been performed properly according to the owner's
manual?
n Are the amplifi er and speakers operating properly?
If the unit fails to operate properly, check out the remedial action in the table below according to the
symptoms present, and see if this fi xes the problem.
Types of trouble which are not described in the table below may indicate trouble in the unit itself so consult
with your dealer from whom you purchased the unit. If your dealer does not know what action to take,
contact one of our customer service centers or your nearest repair service center.
Service centers are listed at http://www.d-mpro.com.
Symptom Cause
The power fails to • The AC power cable is not connected
turn on. to the power outlet.
No sound is heard • One or more of the connecting cables
or the volume have not been connected properly.
level is low. • The SOURCE SEL LN1/LN2/LN3/
LN4/USB/P1–4 controls have not
been set to the correct positions.
• The ducking function of the
microphone has been activated.
The sound is • The master output audio level is too
distorted. high.
• The input level is too high.
The fader start • One or more of the connecting cables
of the CD player have not been connected properly.
cannot be • The CH FADER START switch and
initiated. CROSSFADER START switch have
not been set to the ON position.
Remedy Page
• Connect the AC power cable to 9
the power outlet.
• Check the cable connections. 7
• Set the SOURCE SEL LN1/LN2/ 10
LN3/LN4/USB/P1–4 controls to
the position which corresponds
to the component now playing.
• Set the DUCKING ON/OFF 11
button to the OFF position.
• Adjust the MASTER LEVEL 10
control.
• Adjust the channel input LEVEL 10
controls.
• Connect the CD player to the unit 7
using the stereo mini jacks.
• Set the CH FADER START switch 14, 15
and CROSSFADER START
switch to the ON position.
n DN-X1600 does not operate normally or no sound is produced
• Are the USB cable, audio cables, etc., properly connected?
• Is the volume setting for the source, audio device, application, OS, etc., properly
raised?
• Is the appropriate device selected on your audio application?
• Is the sampling frequency setting appropriate?
Either make the same settings in the DN-X1600's preset mode and on the application.
• Are there WAV files with different sampling frequencies and bit rates?
Depending on your audio application, it may not be possible to play WAV files with
different sampling frequencies and bit rates simultaneously.
• Is other USB equipment in use?
If other USB devices are connected, try connecting only DN-X1600 to check for
problems.
• Is the USB connector of the connected computer compatible with USB 2.0
(Hi-Speed)?
Use a USB 2.0-compatible cable.
n Sound is broken or distorted
• Are other applications or device drivers operating?
Close any unneeded applications.
• Are you playing multiple WAV files?
When playing multiple WAV files simultaneously, depending on the capacity of your
computer, the sound may be broken.
ENGLISH
27