Table of Contents
Advertisement
Installation Steps
MegaRAID provides extensive customization options. If you need only basic MegaRAID features
and your computer does not use other adapter cards with resource settings that may conflict with
MegaRAID settings, even custom installation can be quick and easy.
Step
1
2
3
4
5
6
7
8
9
10 Connect the SCSI cables to SCSI devices.
11 Set the target IDs for the SCSI devices.
12 Replace the computer cover and turn the
13 Run MegaRAID Configuration Utility.
14 Install software drivers for the desired
Each step is described in detail below.
Action
Unpack the MegaRAID controller and
inspect for damage. Make sure all items are
in the package.
Turn the computer off and remove the
cover.
Make sure the motherboard jumper settings
are correct.
Install cache memory on the MegaRAID
card.
Check the jumper settings on the
MegaRAID controller.
Set SCSI termination.
Set SCSI terminator power (TermPWR).
Connect the battery harness
Install the MegaRAID card.
power on.
operating systems.
Additional Information
If damaged, call LSI Logic
Technical Support at 678-
728-1250.
16 MB minimum cache
memory is required.
See page 53 for the
MegaRAID jumper
settings.
optional
Be sure the SCSI devices
are powered up before or at
the same time as the host
computer.
Optional.
Chapter 6 Hardware Installation
Cont'd
49
Advertisement
Table of Contents
