Dos Aspi Driver Error Messages - LSI MegaRAID Enterprise 1600 Hardware Manual

DOS ASPI Driver Error Messages

LSI Logic ASPI Manager has
NOT been loaded.
Controller setup FAILED
error code=[0xab]
No non-disk devices were
located
'ERROR: VDS support is
*INACTIVE* for
MegaRAID logical drives
112 MegaRAID Enterprise 1600 Hardware Guide
Message
The ASPI manager is not loaded. One of the failure
codes listed below is displayed next.
Correct the condition that caused the failure. The
failure codes are:
0x40
0x80
0x81
0x82
0x83
0x84
0x85
0x90
The driver did not find any non-hard drive devices
during scanning. A SCSI device that is not a hard disk
drive, such as a tape drive or CD-ROM drive, must be
attached to this SCSI channel. The SCSI ID must be
unique for each adapter and cannot be SCSI ID 0. The
supported SCSI IDs are 1, 2, 3, 4, 5, and 6.
The /h option is appended to driver in
CONFIG.SYS or this driver is used with a BIOS that
is earlier than v1.10, or no logical drives are
configured.
Corrective Action
No MegaRAID adapters found
Timed out waiting for interrupt to be posted
Timed out waiting for the MegaRAID
Response command.
Invalid command completion count.
Invalid completion status received.
Invalid command ID received.
No MegaRAID adapters found or no PCI
BIOS support.
Unknown Setup completion error