Bios Boot Error Messages - LSI MegaRAID Enterprise 1600 Hardware Manual

BIOS Boot Error Messages

Adapter BIOS Disabled.
No Logical Drives
Handled by BIOS
Host Adapter at Baseport
xxxx Not Responding
No MegaRAID Adapter
Configuration of
NVRAM and drives
mismatch.
Run View/Add
Configuration option of
Configuration Utility.
Press any key to run the
Configuration Utility.
Message Problem
The MegaRAID BIOS is
disabled. Sometimes the
BIOS is disabled to
prevent booting from the
BIOS.
The BIOS cannot
communicate with the
adapter firmware.
The BIOS cannot
communicate with the
adapter firmware.
The configuration stored
in the MegaRAID adapter
does not match the
configuration stored in the
drives.
Suggested Solution
Enable the BIOS via the
MegaRAID Configuration
Utility utility.
Make sure MegaRAID is
properly installed.
Try moving the
MegaRAID card to
another PCI slot.
Run the MegaRAID
Manager Diagnostics to
verify that MegaRAID is
functioning properly.
Make sure MegaRAID is
properly installed.
Move the MegaRAID
card to another PCI slot.
Run the MegaRAID
Manager Diagnostics to
verify that MegaRAID is
functioning properly.
Press a key to run
MegaRAID Manager.
Choose View/Add
Configuration from the
Configure menu.
Use View/Add
Configuration to examine
both the configuration in
NVRAM and the
configuration stored on
the disk drives. Resolve
the problem by selecting
one of the configurations.
Chapter 8 Troubleshooting 109