SCSI Termination,
Continued
Terminating External Disk Arrays In most array enclosures, the end of the SCSI cable has an independent SCSI
terminator module that is not part of a SCSI drive. In this way, SCSI termination is not disturbed
when a drive is removed. MegaRAID termination should always be enabled or controlled by
software. Make sure J2, J3, J5, and J7 are either always open (termination always enabled), or Pins
1-2 are shorted (termination controlled by software).
Note: Channels C and D have only external connectors, so termination should always be either
anabled or under software control on these two channels.
58
MegaRAID Enterprise 1600 Hardware Guide