Step 7 Set Scsi Terminator Power - LSI MegaRAID Enterprise 1600 Hardware Manual

Step 7 Set SCSI Terminator Power

J9, J10, J11, J12 These jumpers control TermPWR for the MegaRAID SCSI channels. See the documentation for
each SCSI device for information about enabling TermPWR. The factory settings supply
TermPWR from the PCI bus.
The SCSI channels need Termination power to operate. If a channel is not
being used and no auxiliary power source is connected, change the jumper
J9
J10
J11
J12
Important
setting for that channel to supply TermPWR from the PCI bus.
SCSI Channel A – Short Pins 1-2 for PCI power.
SCSI Channel B – Short Pins 1-2 for PCI power.
SCSI Channel C – Short Pins 1-2 for PCI power.
SCSI Channel D – Short Pins 1-2 for PCI power.
Chapter 6 Hardware Installation 61