Table of Contents
Advertisement
6.2
Installation Steps
6-2
The MegaRAID SCSI 320-1 provides extensive customization options. If
you need only basic MegaRAID SCSI 320-1 features and your computer
does not use other adapter cards with resource settings that may conflict
with MegaRAID SCSI 320-1 settings, even custom installation can be
quick and easy.
Table 6.1
lists the hardware installation steps. Each step is described in
detail in the following pages.
Table 6.1
Hardware Installation Steps
Step
Action
1
Unpack the MegaRAID controller and
inspect for damage. Make sure all items
are in the package.
2
Turn the computer off and remove the
power cord, and remove the cover.
3
Check the jumper settings on the
MegaRAID SCSI 320-1 controller.
4
Set SCSI termination.
5
Install the MegaRAID SCSI 320-1 card.
6
Connect the SCSI cables to SCSI devices.
7
Set the target IDs for the SCSI devices.
8
Replace the computer cover and turn the
power on.
9
Run the MegaRAID BIOS Configuration
Utility.
10
Install software drivers for the desired
operating systems.
Hardware Installation
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Additional Information
If damaged, call your LSI
Logic OEM support
representative.
See
page 6-3
for the
MegaRAID SCSI 320-1
jumper settings.
Be sure the SCSI devices
are powered up before, or
at the same time as, the
host computer.
Optional.
Advertisement
Table of Contents
