Table of Contents
Advertisement
Checklist
Perform the steps in the installation checklist:
Check
48
MegaRAID Enterprise 1600 Hardware Guide
Step
1
Turn all power off to the server and all hard disk drives,
enclosures, and system, components.
2
Prepare the host system. See the host system technical
documentation.
3
Determine the SCSI ID and SCSI termination
requirements.
4
Make sure the jumper settings on the MegaRAID
controller are correct. Install the cache memory.
5
Connect the battery pack harness to J23 (optional)
6
Install the MegaRAID card in the server and attach the
SCSI cables and terminators as needed. Make sure Pin 1
on the cable matches Pin 1 on the connector. Make sure
that the SCSI cables you use conform to all SCSI
specifications.
7
Perform a safety check. Make sure all cables are properly
attached. Make sure the MegaRAID card is properly
installed. Turn power on after completing the safety
check. Connect the battery pack.
8
Install and configure the MegaRAID software utilities and
drivers.
9
Format the hard disk drives as needed.
10
Configure system drives (logical drives).
11
Initialize the logical drives.
12
Install the appropriate MegaRAID drivers for your
operating system.
Action
Advertisement
Table of Contents
