Advanced Options Menu - Lowrance GlobalMap 7200C Operation Instructions Manual

2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the temp sensor you want to rename and press
vice Configuration menu will appear with the Device Name dialog box
highlighted.
4. Press and use ↑ ↓, ← → to input the desired name for the temp
ENT
sensor. Press
ENT
To select Temp Type:
1. Press
MENU
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the desired temp sensor and press
tion menu will appear.
4. Highlight
T
will appear: Water, Outside, Inside, Engine Room, Cabin, Live Well,
Bait Well, Refigeration, Heating System and Unknown.
5. Highlight the desired Temp Type and press
firmation message will appear: Are you sure you wish to change this
device's configuration?
6. Highlight
Y
main display.

Advanced Options menu

The Temp sensor Advanced Options menu contains two categories: In-
stance and Restore Defaults.
Instance
The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to re-
solve certain electronic probe conflicts. This is most likely to occur if the
network includes LMF-200 or LMF-400 digital gauges, which support
the display of fewer electronic probes than your GPS or sonar/GPS unit.
If you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service.
You should never need this command if you are connecting your unit to a
network with similar display units and/or a series of electronic probes.
and press
S
US ETUP
. Press
EXIT
, use ↑ ↓ to select
|
MENU
and press
S
US ETUP
and press
T
EMP YPE
and press
ENT
ES
, which will open the Bus Configu-
ENT
repeatedly to get back to the main display.
NMEA 2000
, which will open the Bus Configu-
ENT
. The following list of Temp Types
ENT
. Press
EXIT
131
and press
. The Device Configura-
ENT
. The following con-
ENT
repeatedly to get back to the
. The De-
ENT
. The
ENT