Fuel Flow Calibration In A Suzuki Engine Interface - Lowrance GlobalMap 7200C Operation Instructions Manual

11. Highlight
pear: Half Level Calibration Completed. Press
12. Add another quarter tank of fuel, which should raise the fuel level
to 3 quarters of a tank. Highlight
and press
L
EVEL
Select
13. C
ALIBRATE
Qtr Level Calibration Completed. Press
14. Top off the tank, highlight
and press
L
EVEL
Select
15. C
ALIBRATE
Full Level Calibration Completed. Press
edly to get back to the main display.

Fuel Flow Calibration in a Suzuki Engine Interface

The default calibration for the Suzuki Engine Interface is adequate in
most cases, but if Fuel Used readings are off by more than 3 percent,
calibration is recommended.
To check engine interface accuracy:
Select Fuel Used to be shown as Overlay Data on your unit's main dis-
play. Refer to the Overlay Data segment of this manual for instructions
on how to select Fuel Used data as Overlay Data.
1. After selecting Fuel Used as overlay data, fill up your tank and press
| .
MENU MENU
2. Select
NMEA 2000
3. Highlight
F
press .
ENT
4. Use ↑ ↓ to select the location (Port, Center or Starboard) of the en-
gine interface you want to calibrate and press
5. Highlight
F
sage will appear: Are you sure you wish to Fill Tank?
6. Select and press
Y
ES
appear: Do you wish to re-calibrate the device?
7. Highlight
N
burn at least five gallons of fuel. Be sure you run only ONE engine
— the engine connected to your engine interface.
9. Fill up your tank again, noting how much fuel you added to the tank.
Compare that number to the Fuel Used figure displayed on the page
you customized. If the amount of fuel you added to the tank and the
fuel used figure are off by more than 3 percent, we recommend the en-
gine interface be calibrated.
and press
C
ALIBRATE
ENT.
and press
ENT.
and press
and press
M
UEL ANAGEMENT
and press
T
ILL ANK
ENTER
and press
ENT
O
. The following message will ap-
ENT
F L
LUID EVEL
. The following message will appear: 3
ENT
ENT
F L
LUID EVEL
. The following message will appear:
ENT
ENT
.
ENT
and press
ENT
. The following confirmation mes-
ENT
. The following confirmation message will
. Take your vessel out on the water and
143
.
ENT
and press
ENT
.
and press
ENT
, then press
. Select
T
ANK
.
ENT
. Select
3 Q
TR
. Select
F
ULL
repeat-
EXIT
and
L
OCATION