Table of Contents
Advertisement
To get to the GPS Simulator:
1. Press
MENU
2. Press
to
↓
S
3. Press
to
↓
GPS S
GPS Setup Menu (left); GPS Simulator menu (right).
Make the desired settings, then turn the simulator on by highlighting
the
GPS S
IMULATOR
to clear this menu. A message and tone appear periodically, warning
you that the simulator is on. To turn the simulator off, repeat the above
steps or turn off the unit.
While in simulator mode, you can press
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, select
the
S
TEER WITH
return to the previous page.
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. Go to the simulator menu as shown above. Pick a
near the beginning of your trail/route. Enter an approximate
in compass degrees) that will point you toward the start of the trail/route.
2. Set
to zero. Select
S
PEED
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
press
to increase speed to the desired setting.
↑
|
|
to
↓
MENU
S
|
ENT
IMULATORS
O
IMULATOR
box and pressing
O
N
command, press
A
RROWS
to clear the alarm.). When navigation starts,
EXIT
|
S
ENT
YSTEM
ETUP
. The GPS Simulator Menu appears.
| ENT
N
ENT
ENT
S
A
TEER WITH
RROWS
81
.
key. Press
to clear the steering and
EXIT
, then press
EXIT
S
TARTING
command and press
|
|
EXIT
EXIT
EXIT
|
|
EXIT
EXIT
at or
P
OSITION
(shown
T
RACK
ENT
to
,
Hide quick links:
Advertisement
Table of Contents
