Ep-15 Fluid Level Calibration - Lowrance GlobalMap 7200C Operation Instructions Manual

EP-15 Fluid Level Calibration

The default calibration for the EP-15 Fluid Level is just as accurate as
standard fluid level gauges. If, however, the tank has an irregular
shape or greater accuracy is needed, calibration is recommended. There
are three calibration options: 2-Point, 3-Point and 5-Point.
2-Point Calibration
A 2-point calibration is best suited for rectangular or square-shaped
tanks, where the capacity of the top half of the tank matches the capac-
ity in the lower half of the tank. In a two-point calibration, you will set
two points, one each for empty and full levels. You can begin calibra-
tion at either of the two points, but we recommend starting with an
empty tank. You will fill the tank to complete calibration.
1. Press
MENU| MENU
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the EP-15 Fluid Level and press
4. Press ↓ to select
menu will appear. Instructions on Calibration will be listed at the top
of the menu.
5. Highlight
N
6.
Select F L
LUID
7. Make sure the fuel tank is empty, highlight
The following message will appear: Empty Level Calibration Com-
pleted.
Press ENT.
Fill up your tank, highlight
8.
Select
9. F L
ULL
The following message will appear
10.
pleted. Press
ENT
display.
, use ↓ ↑ to select
and press
S
US ETUP
C
ALIBRATE
, press
P ENT
UM TS
, press ENT, then select E
EVEL
and press
EVEL
, then press
NMEA 2000
, which will open the Bus Configu-
ENT
ENT
and press
ENT
and select
2.
MPTY
and press
F L
LUID EVEL
Highlight
ENT.
Full level Calibration Com-
:
repeatedly to get back to the main
EXIT
140
and press
.
. The Device Calibration
Press .
ENT
press
L and
EVEL
and press
C
ALIBRATE
ENT.
and press
C
ALIBRATE
.
ENT
ENT.
.
ENT
ENT.