Advanced Options Menu - Lowrance GlobalMap 4800M Product Support Bulletin

3. Select the fuel flow you want to rename and press
Configuration menu will appear with the Device Name dialog box high-
lighted.
4. Press
ENTER
flow. Press
ENT
To select a Location:
1. Press
MENU| MENU
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the desired fuel flow and press
menu will appear.
4. Select
L
OCATION
with following options: Port, Center, Starboard and Unknown.
5. Highlight the desired location and press
will appear: Are you sure you wish to change this device's configuration?
5. Select
Y
ES
main display.

Advanced Options menu

The Fuel Flow sensor Advanced Options menu contains two categories:
Instance and Restore Defaults.
Instance
The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to re-
solve certain electronic probe conflicts. This is most likely to occur if the
network includes LMF-200 or LMF-400 digital gauges, which support
the display of fewer electronic probes than your GPS or sonar/GPS unit.
If you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service. You should never
need this command if you are connecting your unit to a network with
similar display units and/or a series of electronic probes.
Restore Defaults
The Restore Defaults command allows you to reset an individual EP-10
Fuel Flow Sensor's settings to factory defaults. If, for example, you exe-
cute the Restore Defaults command from your Port Fuel Flow Ad-
vanced Options menu, only the settings for the Port Fuel Flow will be
reset to factory defaults. Other fuel flows on the network will not be
affected.
and use ↑ ↓, ← → to input the desired name for the fuel
. Press
EXIT
, use ↑ ↓ to select
and press
S
US ETUP
and press
and press
ENT
repeatedly to get back to the main display.
NMEA 2000
, which will open the Bus Configu-
ENT
ENT
, which will open the Location menu
ENT
. Press
EXIT
20
ENT
and press
. The Device Configuration
. The following message
ENT
repeatedly to get back to the
. The Device
. The
ENT