Lexmark X792de Operation Instructions Manual page 29

Media Handling
MEDIA INPUT
The Lexmark X792de Color Laser MFP comes standard
with one 550-sheet paper drawer and a 100-Sheet
Multipurpose Feeder. For high-volume printing, a 2,000-
Sheet High Capacity Feeder can be added increasing the
total capacity to 2,650
automatically feed paper weights from 60 to 176 gsm (16
to 47 lb bond) grain long. Paper lighter than 60 gsm (16 lb)
might not be stiff enough to feed properly and can result in
paper jams. For optimal
recommends the use of 75 gsm (20 lb bond) grain long
paper. For paper smaller than 182 x 257 mm (7.2 x 10.1
in.), Lexmark recommends 90 gsm (24 lb) or heavier
paper. For duplex printing, the Lexmark X792de supports a
range of paper weights between 60 g/m
47 lb bond) paper. Card stock including 65 lb cover, 90 lb
Bristol, and 100 lb tag is also supported in simplex and
duplex modes.
Media Handling Checklist
Minimum/Maximum Media
Weight (550-sheet paper
drawer) (Multi-Purpose Tray
Feeder)
Minimum/Maximum Duplex
Printing
Feeds maximum media weight
from all sources?
Offset Stacker
Finisher
Hole Punch
The Lexmark X792de Color Laser MFP shown here is
equipped with one standard 550-sheet drawer and a 100-
sheet multipurpose feeder.
Copyright © 2011 BERTL Inc.
All Rights Reserved. The license under which this document is made available and applicable law prohibit any reproduction or further transmission of any portion of this document. This
document may only be viewed electronically through the www.BERTL.com Web site and may not be stored in electronic or hard copy format. Any reproduction of trademarks is strictly
prohibited. BERTL accepts no responsibility for any inaccuracies or omissions contained in this document.
sheets. The device can
performance, Lexmark
2
–176 gsm (16 lb–
2
16 lb bond ( 60 g/m )/
2
47 lb bond (176 g/m )
2)
16lb bond (60 g/m /
2
47 lb bond (176 g/m )
Yes
Yes (Optional)
Yes (Optional)
Yes (Optional)
The 100-sheet multipurpose feeder is located on the left
side of the device. The feeder can be accessed by
lowering the tray down and can be adjusted by sliding the
levers into place. The feeder can be adjusted for envelope
printing.
The multipurpose feeder can hold several sizes and types
of print media, such as transparencies, labels, card stock,
and envelopes. It can be used for single-page or manual
printing, or as an additional tray. The multipurpose feeder
can hold approximately:

100 sheets of 75-gsm (20-lb) paper

10 envelopes

100 transparencies
The multipurpose feeder accepts paper or specialty media
within the following dimensions:

Width—89 mm (3.5 in.) to 229 mm (9.02 in.)

Length—127 mm (5 in.) to 1270 mm (50 in.)
LOADING MEDIA
Media Loading Checklist
Drop-in loading of a full ream of paper?
Spring-loaded ramps in paper trays?
Geared media size side guides?
Captured rear media guide?
Automatic paper size detection?
January 2011
Lexmark X792de MFP
www.BERTL.com
Yes
No
Yes
Yes
Yes
January 2011
Page 29