Lexmark X792de Operation Instructions Manual page 22

Ease of Use
Once the front panel door is open, the user simply pulls the
appropriate green lever and slides the unit out for
replacement.
REPLACING FUSER UNIT
In order to replace the fuser unit, the user must first pull
open the side door.
The user then releases the two gray side latches located
on each side of the fuser.
Copyright © 2011 BERTL Inc.
All Rights Reserved. The license under which this document is made available and applicable law prohibit any reproduction or further transmission of any portion of this document. This
document may only be viewed electronically through the www.BERTL.com Web site and may not be stored in electronic or hard copy format. Any reproduction of trademarks is strictly
prohibited. BERTL accepts no responsibility for any inaccuracies or omissions contained in this document.
Once unlatched, a set of handles are revealed and the
user uses them to pull out the unit for replacement.
The handles on the fuser make it very easy for the user to
replace the unit. Users should be cautious when handling
the fuser as the unit can be very hot.
REPLACING WASTE TONER BOX
Users must periodically empty the device's waste toner
bottle located on the lower front side of the device.
January 2011
Lexmark X792de MFP
www.BERTL.com
January 2011
Page 22