Operation; Control Panel - Kenmore 405.84086 Use & Care Manual

CONTROL PANEL
/
O
MODE button
Press this button to select the
operating mode in a sequence
that advances from AUTO to
COOL to DRY to FAN. An indicator
light will illuminate for each mode
setting.
O SLEEP button
Used to initiate the SLEEP operation.
O
UP(>) and DOWN (<) button
Pressto increase or decrease
temperature settings in 2°F (1°C)
increments from 62°F (17°C) to
88°F (30°C), or TIMER setting
from 0 to 24 hrs.
NOTE: Temperature can be displayed
in Fahrenheit or Celsius. To change
from one to the other, press and hold
the Up and Down buttons at the same
time for 3 seconds.
O POWER button with OPERATION
indicator
Power switch on/off.
O TIMER button
Used to initiate the AUTO ON start
time and AUTO OFF stop time program,
in conjunction with the < & > buttons.
An indicator light will illuminatewith
each setting.
0
@
0
FAN button
Press to select four different fan
speed settings: LOW, MED, HI
and AUTO. An indicator light
willilluminate for each speed
setting.
LED Display
Shows the set temperature in °C or
°F and the Auto-timer settings.
While in DRY and FAN modes, the
display shows the room temperature.
TEMP SENSOR feature
NOTE: This feature can be activated
from the remote control ONLY. The
remote control serves as a remote
thermostat allowing for precise
temperature control at its location.
To activate the TEMP SENSOR feature,
point the remote control towards the
unit and press the TEMP SENSOR
button. The remote display shows the
actual temperature at it's location. The
remote control will send this signal to
the Air Conditioner at intervals of every
3 minutes until pressing the TEMP
SENSOR button again.
If the unit does not receive the TEMP
SENSOR signal during any 7 minute
interval, the unit will beep to indicate the
TEMP SENSOR mode has ended.
13