Operating Condition; Suggested Tools For Window Kit Installation; Electrical Information - Kenmore 405.84086 Use & Care Manual

15.The AirConditioner should b econnected toa 115 V ,60Hz,15- o r 20-amp
fused 3 prong grounded outlet.
16.Always i nsert thefilters securely. Clean t hem
every two weeks. Operation without
filters may cause failures.
OPERATING CONDITION
o The Air
Conditioner
must be
operated
within the
temperature
range
indicated below:
MODE ROOM TEMPERATURE
COOL 62°F (17°C) - 95°F (35°C)
DRY 55°F (13°C) - 95°F (35°C)
Suggested tools for window kit installation:
1. Screwdriver (medium size Phillips)
2. Tape measure or ruler
3. Knife or scissors
4. Saw (in the event the window kit needs to be cut down in size because
the window is too narrow for direct installation)
`&WARNING:
For Your Safety:
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of
this or any other appliance.
Avoid fire hazard or electric shock. Do not use an extension cord or an adaptor plug.
Do not remove any prong from the power cord.
,&WARNING:
Electrical information:
Be sure the electrical service is adequate for the model you have chosen. This
information can be found on the serial plafer which is located on the side of the
cabinet and behind the grille.
Be sure the Air Conditioner is properly grounded. To minimize shock and fire hazardsr
proper grounding is important. The power cord is equipped with a three-prong
grounding pbg for protection against shock hazards.
Your Air Conditioner must be used in a properly grounded wail receptacle. If the
wall receptacle you intend to use is not adequately grounded or protected by a time
delay fuse or circuit breaker_ have a qualified electrician install the proper receptacle.
Ensure the receptacle is accessible after the unit installation.